The whole airbox? Or are the rubber boots removable?
Sync tool ordered, and contacted dannymax about jets and af screws.
Just need to order a drillbit for the slidehole and I think I'm set. :biglaugh:
Any size suggestions?
Also checked out the jet swap and carb rebuilding threads. This forum...
What size is the original slide hole? I can order a dremel bit i guess and remake it.
And another issue i had was with the airbox boots, was a pain to get it back on the carbs. They where a bit short, like the rubber had dried out. Is there any solvents i can soak them in to restore them?
Thanks guys, I'll start by getting a new af screw and the sync tool. Then i'll reinstall original jets.
The aftermarket exhaust is a short free flow set. It would be extremely noisy.
Hi
i purchased a VMAX, that had previously been set up with an aftermarket exhaust. Now the original is back on and its running a bit rich. Engine running cold and poor milage.
Should i return the original pilot air screws?
What main jet size would be recommended for kn filter with airbox...
Hi,
I'm having some issue with my sending unit. Tested the gauge by grounding it to the copper base of the sensor and it maxed out. So i know It's the sensor.
Can anyone recommend a replacement unit or maybe tell me what the threads are called?
Cheers!
I'll have a go at the original light and measure the insert lugs etc. If i can find a projection based insert, ie domed leds or hids, that fit. It would be better. They don't rely on a reflector, so the small size shouldn't affect light output or distribution.
Saving the electrical until i...
I measured the battery at charging, I will try again at the bulb connectors with load to see if there's any bad connection. The headlight looks a bit matted though, so I think I will need a new insert anyway. That's why I was thinking of one of these led upgrades.
They use them on jeeps, where...
Hi,
my headlights a bit dim, and Im considering putting in a led insert or changing the whole light.
Has anyone tried fitting something like the HD Daymaker China copy or similar
I was thinking of bying an EMGO 7inch lamp kit and a Chinese copy like in the link. Has anyone done something like...