gentsvmax's latest activity

Try swapping the ignition coil for the bad cyl to another location and see if the miss follows the change. The right front is the #4...

At minimum I would split the rack, get the #4 carb off and apart for a soak in the carb cleaner. The Ultra-bath is best, ultrasonic with...

Look at your amazon choice, country of origin

Yea, there are a few hidden value item's out there. in lighting are some good examples. Daymaker, for example, about 250 for my version...

This site has some real die hard want to help helpers, 5 replies with earnest suggestions to an obviously none mechanically inclined can...

Make sure that your meters are correct by switching lines when the engine is running to see if the correct pressures transfer to the...

These carbs require a very thorough, complete disassembly and cleaning. I mean a carb clean soak minimum, ultrasonic bath being the best...

I have always broke them in pretty hard ! I figure after the Dyno time it should be pretty good. I have not been giving it a whole lot...

I have already put a couple hundred miles on it and running it somewhat hard. I figure if it held up on the dyno it's good to go.lol

Hey TooOld, whew! finally got those dims. 18.5" both sides, hyme joint eye center to center.

I love this thing with the new motor! It's not high hp in today's standards but 500 hp and 514 lbs of torque in a 2600 lb truck is Fun !

Im on my way back in to Denver tonight, will shoot them to ya in the am. Sorry for the delay brother!

My journey is short with the Vmax, I always wanted one. I picked up my bike in May and it needed nothing but I wanted to be sure so I...

Thanks @gentsvmax that is one bad ass looking ride!

This thing has been occupying my lift for the past 5 years as I struggled to muster the motivation to finish powder coating the engine...