Recent content by hh3130

I think I'll try it out when I find time and a tps. Sent from my SGH-I747M using Tapatalk 4

Thanks RempageR1. I would like to try a tps instead of a map sensor. Did you find any difference or advantage? Sent from my SGH-I747M using Tapatalk 4

Very nice job. :clapping::worthy: Is it a 0-5vdc 3 wire TPS? and do you happen to know what the sensor was originally designed for? Do you find the TPS works better for the IGNITECH then a MAP sensor? :clapping::clapping::clapping:

Hi Sean, I'd be very interested to know how it works for you, when you have a chance to try it out. I think I'm going to try installing it this winter, when I hopefully have more time and I'm not riding it.

It would be the easiest. But harder on the wallet. lol

Thanks for sharing the info RempageR1. I would also be interested in the TPS your using and how you mounted it. Thanks again!

I'm seriously looking at installing EFI on my 85 vmax. Has anyone installed the roadstercycle EFI kit? and/or worked with the microsquirt controller?

Gary, I don't have the failed MAP sensor. Probably threw it out after I verified the replacement worked from a local auto parts store. I'm not worried about warranty, since I wanted to use the bike ASAP I just picked up a replacement. Never though that you may want to check the sensor out...

Thanks for info Gary. I did replace the 6 pin connector, because it looked in poor shape when installing the ignitech. I'll see if I still have the failed MAP sensor. I'll pull the alternator cover and visually check it or should I just replace it as a prevenative measure? The pickup coils ohm...

Yes they call it a wet float level check. It should be 17mm below the markings on the side of the carb body. Sent from my SGH-I747M using Tapatalk 4 Beta

So I checked the level a few hours later and the level is stable like you said. It's weird it only does it on cyl 1 & 4 though.

Well I'm going to set the level higher and see if it makes a difference.

Key is off and pump is up to pressure. Had the carbs apart many times due to rust, which I seemed to have stopped. Just disassembled and cleaned about a month ago. The levels on the two carbs are quite low but I don't see how they would bounce.

Ok you should be able to see it now.

Sorry guys I'll fix that.