Ok Thanks Steve.
We did replace the copper washers, and all surfaces seemed clear.
We replaced the parts correctly (As per photos) again after, and still had no luck.
I dont have the kit to reverse bleed, so may need to hand it over to the bike shop :(
Nick
Hi Steve,
I forgot to mention, that when the MC was first rebuild using the parts in the same order as the picture, it would bleed with pressure and then all of a sudden release a bunch of bubbles into the MC reservoir and you would loose feeling at the lever.
Both the feed and return holes...
Hi,
Thanks both for the replies.
I have the Haynes Manual, and fitted the seals with the open end facing the Banjo bolt as per the image (without sliding the last seal over the wide part of the shaft. When refitted and the lever pumped it would flow no fluid. i could remove the banjo and...
Hi All,
Apologies if this has been covered, i did try a search and couldn't see what i needed.
Im having some issues with the front brakes on my 1987 VMAX 1200, It all started when the brake lever would stick in when pulled. The brakes were bled to prevent the lever travelling to the...