Actually, and sorry to say - yes. But I have the manual and I have swept through it briefly. These symptoms I had are not mentioned in the manual.
The situation last autumn was that I had the rear left cylinder runnig poorly. And after carb clean, the both right hand cylinders were of...Soo I...
Status update : 3rd time disassemble carbs from bike😅 I start being quite fast in it now... Getting them ultrasound... I believe something is with idle circuit or that little nozzle mentioned abowe messages.
If I measure 12V voltage near headlight I get 11,3V at the same time straight from battery it is 12,5. Ignition on. What could be the cause of voltage loss?
Homework done... No affect 😐 I can do carb removal from bike, disassembly, assembly back and start the bike in 6hrs 🤩 next time in 3hrs I think. . But...damn it didn't help, runs maybe even worse.. Removed now the coils, gonna get them checked tomorrow.
How is the fuel level measured? I adjusted it like this to the somewhat horizontal position in all carbs, by blowing air in the needle valve port and checked when the valve was closed.
If I'd measure these dimensions what would they be?
Is the 'A' dimension the official measure, mentioned in...
Yep.... Actually splitting is not a promblem, I just had the carbs in pieces and for cleaning, this was the first start after re-assembly 🤔 Maybe there were some dirt left somewhere.
I also need a genuine carburettor repair/jet kit, where could I get one? (Finland)
Actually yes, something was happening when I drove it. Like 1/2 or 3/4 throttle , it feeld like all four would be firing! Only a couple of times tho. Idle and full throttle always in V2 mode...
What could it be🤔 Could it be too rich? I do not know the aize of main jet, but this ia canadian...