Recent content by WolfMax

This is a bit old now but here's what i did. Clutch pipe is braded now! Also fitted this: (Link) It also works during normall riding of the bike but as the servo isn't fully open till 8k rpm, you don't see it until then.

You know when you want to say somthing but the words just run away with themselves... Thanks MM for saying it so succinclty. Cheers

If the resistance if the original coil is the same as a COP, then run the COPs in parallel and put a ballast resistor half the resistance value of one COP in line between the ignition and the COPS. This is because 2 COPs in parallel will be half the resistance so you need the ballast to make up...

I found the problem is if you have a TBoost 2 with the off position. It uses a 12v bias feed to keep the VBoost controller happy when it disconnects the wires from the coils. When the wires are connected for 3k or 6k, the bias voltage is still there and seems to have an adverse effect when COPs...

The last post on this was nearly 2 years ago, so I'm wondering if anyone discovered a definitive cause for the TBoost / COPS issue (seems I may have it too as I have COPS without ballast resistors and my TBoost doesn't work even at 6k but the servo cycles at startup). If it is a resistance issue...

I once bought a 1200 Shovel Head Dyna Glide turned Wide Glide instead of a Vmax. It then took me 11 years before I finally got my Max. Did I make a mistake?... Yes and no. Yes, because I would have had the bike I always wanted much sooner although the HD was fun to ride and stopped on a...

Hi Gary SvenDGAF asked for an all-in price for shipment to the UK, I also would like to know the cost please. Have you had chance to test the TCI with a Vboost servo? Apart from the guy who said the manual suggests testing the Vboost servo with 12v, did you have any other replys on the actual...

Is the V45 everyone is going on about, this one: The 3 bikes I always wanted back in the 80's were: VMax (naturally) ZL1000 Eliminator VF750C (British version looked like the above but was just called 'VF750 Custom') Cheers

Ok. This mod will allow you to use the standard bulb in the centre consol indicator light when using LED indicators without ballast resistors or if you just want to replace the little bulb with an LED unit. Note: If you see any white squares with red X's inside, just right click on them and...

Deleted double post of the one below

You got it. that is excatly right. It is then just a matter of working out which wire is left and which is right. But if you describe the wire colours as Choclate and Dark green, I think if you look at the diagram again you should see the relationship between the wires and the switch.

Thanks all for the replys. In answer to the above, I am using a distance measuring counter. The pulse from the speedo is generated by a reed switch activated by the front wheel rotating. The number of pulses per rotation lets you work out the didstance the bike has traveled (542 is approx...

This info is intended for people who have at least a basic knowledge of electronics or can understand a schematic to create a circuit. If you build this, I take no responcibility if after fitting, it fails and frys your wiring. It is for this reason that I'm not offering to make them myself...