Search results

Is it possible to take the stage 7 air corrector out and put it in another carb? I have tried everything I can think of short of breaking it out of the old carb (which still isn't off the table...) Thanks, Taylor

I put my carbs back on after adjusting the float levels, went to start the bike, and gas was pouring out the right rear carb. I checked the screws and one was very loose. Turns out I must have over tightened it and snapped off the bottom corner of the carb. Anyone have any ideas on a fix? Or a...

I noticed I am missing a few dust covers. I plan on replacing them, but I am not sure how quickly I should it. The dust cap on the driveshaft is missing. I think the part missing on the rear wheel is also a dust cover of some sort, but I am not sure. I used the picture of my other bike to show...

I recently bought an 88 with a stage 7 jet kit and 4 into 1 kerker. It sounds good, but I think it is lacking power, especially at 7,000 rpm. It accelerates smoothly until 6,500 then it will hesitate for half a second, pull to 7,000 and then it is like it hits a rev limiter--no more power. I...

I just bought an 88 Vmax without progressive springs. The bike came with a set of forks from a 96 that are thicker (I guess?). Do I need to bother switching to the 96 forks if I put progressive springs in the original forks? :ummm:

I have a set of rear air shocks that came on the bike when I bought it. There aren't any markings on them that I can find. Any one know what kind of air pressure I should run in them?

I have a koso knock off speedo/tach that has a negative tach feed. Is there any where I can wire it in to make it work? :ummm:

Hey guys, I just bought an electronic speedometer off ebay. It is a fairly generic model with 2 magnets and a sensor. I can't get the speedometer to read higher than 8 mph. Is the pick up not catching the magnets going by? There is a "pulse 9" light that may be adjustable. Anyone have any...