Search results

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. CDNVmax1200

    New Member and Owner

    Managed to get one decent picture this evening with the New exhaust.
  2. CDNVmax1200

    2006 1200 no spark on cyl. 3 possibly also no fuel.

    Problem solved! A bunch of rubbed wires involving the grey tach wire apparently will mess up the #3 coil signal enough to not fire the coil. After looking at the scope I notice that the wave signal was not clean and more erratic looking than the sample provided by 02GF74 and in that I started...
  3. CDNVmax1200

    New Member and Owner

    I'll throw some pics up once the bike is back in one piece, went to throw on a full Voodoo exhaust and ended finding a problem, lol now there's pieces everywhere. 🤦‍♂️
  4. CDNVmax1200

    2006 1200 no spark on cyl. 3 possibly also no fuel.

    Ok so I went through everything again, once I had to ponder things a little more. I check with the scope and there is a signal there. But something seems off on the harness side but I can't put my finger on it. I did plug the #3 coil into the control plug for #1 and got instant spark so I can...
  5. CDNVmax1200

    2006 1200 no spark on cyl. 3 possibly also no fuel.

    I have a scope here, I will check that as well. Thank you for the input!
  6. CDNVmax1200

    2006 1200 no spark on cyl. 3 possibly also no fuel.

    Correct, no spark.
  7. CDNVmax1200

    2006 1200 no spark on cyl. 3 possibly also no fuel.

    Correct I tested coil #3 it seems to be ok, I have trigger signal at the coil Connector #3 and I swapped coil three to cylinder #1 and it fires but #1 will not fire when place in #3's position. It is very strange, I don't work on bikes on a daily basis but I am a ticketed mechanic in automotive...
  8. CDNVmax1200

    2006 1200 no spark on cyl. 3 possibly also no fuel.

    I did pull the wire and cap off and tested it against #1 cylinder they both measured just under 9K ohm, I'll measure the HT side of the coil when I get home. But I did swap the entire coil assembly between #3 and #1 and still no spark on #3 so the coil and I would assume is ok if it fires when...
  9. CDNVmax1200

    2006 1200 no spark on cyl. 3 possibly also no fuel.

    Hello just seeing if anyone has run into this it's a little weird. I have no spark on cylinder 3, I swapped the coil pack and wire/boot with cylinder 1 and it fires ok. Also tested coil at 3 Ohms. Power to connector is good and this is where I'm unsure if this is a valid test or not but I place...
  10. CDNVmax1200

    New Member and Owner

    Hello there from Canuckastan, Just bought my first Vmax a 2006 picked it up after it had been sitting for awhile, Definately have some work to do to get it up too snuff as it has a few issues. Hoping to find some fixes on here and check other rides! Thanks for having me.
Back
Top