Custom made Swingarm inner panel?

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Supercharger

Active Member
Joined
Nov 7, 2016
Messages
43
Reaction score
1
Location
Denmark
Hello Vmax guys.
I'm new here and have a questions :ummm:
Yamaha offer a wide tire rim (240 tire) but the original Swingarm inner plate must be removed.
I don't like the shaft drive is exposed for dirt and water. :damn angry:
Have someone manufactured a slim inner panel plate?
 

Attachments

  • Shaft drive.jpg
    Shaft drive.jpg
    72.8 KB · Views: 34
  • Wide_rim_vmax.jpg
    Wide_rim_vmax.jpg
    23.2 KB · Views: 28
Hello Vmax guys.
I'm new here and have a questions :ummm:
Yamaha offer a wide tire rim (240 tire) but the original Swingarm inner plate must be removed.
I don't like the shaft drive is exposed for dirt and water. :damn angry:
Have someone manufactured a slim inner panel plate?

No.

Some owners just leave it open....when you change the rear tire you can clean that area.

Or, most just cover it with a piece of duct tape. I used black Gorilla tape that you can buy in HD. It sticks unbelievably well and is not noticeable unless you are looking for it.
 
Goodmorning.

Thank you for the answer.
Black duct tape was a good idea.
But surprising someone not have make one "custom part" there. ;)

Now this snowing in the little Denmark now. 10inch snow everywhere. :snow:
 

Latest posts

Back
Top