I installed some new tires and I'm trying to put the wheels back on. Following the instructions in the manual I purchased it tells me to torque down the rear axle before i clamp down the rear axle clamp Bolt. However, when I do that the rear axle spins. When it said to grease the rear axle I also added some to the end piece on the right that has the little hole in it and sits inside where you clamp down the rear axle Bolt. I'm thinking now I wasn't supposed to put grease on that end part? I can pull it back out and remove the grease but it still seems like I should tighten the clamp bolt BEFORE I torque down the axle nut? I'm just not sure if it matters how far in the axle is... Do I stop the axle right at where that little hole in the axle starts? Bikedave99 had a fantastic tutorial that I used when removing. Is there anything similar for 1 installing?
http://www.vmaxforum.net/showthread.php?t=13338&highlight=Remove+rear+tire
Thank you
http://www.vmaxforum.net/showthread.php?t=13338&highlight=Remove+rear+tire
Thank you