Kuryakyn Grips???

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Rusty McNeil

Well-Known Member
Joined
Aug 24, 2006
Messages
5,125
Reaction score
14
Location
Baytown, Texas
Has anyone used the Kuryakyn Universal Iso-grips?

Were they a good fit??

I hope so because I just ordered a set......

I also ordered the Drag bars from UFO....

Any one have them and know if they are gonna be a problem with tank clearance when turning low speed????
Thanks in advance...
 
Grips: I like the large diameter feel of them.
I don't like the feel of small grips on my bike.
I'ts just feels a bit weird to goo up a perfectly good set of bars with all of that glue.
Fit? Bueno

Drag bars: I run the RMS sportmax extra wide and have no tank bangin'.
I'd assume UFO's are similar.
________
video review
 
Last edited:
Depends on how wide they are, will get meaurments of the ones I tried to mount in a minute.

Mine were fairly narrow so hardly had room for the master cylinders, controls and grips. Also it was too low and I ended up snapping the return throttle cables support stem.
Need a set of risers that bring it up maybe half an inch from stock for mine to work.
 
They are same, same just a bit longer on the tips.
I had no clearance probs w/ a straight back level set up.

HERE WE GO
B23: 7/8" Flanders Drag Handlebar Wide Center:
Measurements Degree of Bend: 18 degrees
Pullback: 3.5"
Center: 9"
Width: 31"
Diameter: 7/8"

This is the spec on the bars RMS sells it is stamped FLANDERS B23 on the bar.
________
ipad guide
 
Last edited:
ok, my bars are 25 inches at the widest with 3 and 1/2 inches pull back on them. And like I said they only just didn't clear the faux tank.
 
mine fit fine, but Im getting bored of them, it seems like every cruiser around here has them
 
Back
Top