Kuryakyn Grips???

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Rusty McNeil

Well-Known Member
Joined
Aug 24, 2006
Messages
5,125
Reaction score
14
Location
Baytown, Texas
Has anyone used the Kuryakyn Universal Iso-grips?

Were they a good fit??

I hope so because I just ordered a set......

I also ordered the Drag bars from UFO....

Any one have them and know if they are gonna be a problem with tank clearance when turning low speed????
Thanks in advance...
 
Grips: I like the large diameter feel of them.
I don't like the feel of small grips on my bike.
I'ts just feels a bit weird to goo up a perfectly good set of bars with all of that glue.
Fit? Bueno

Drag bars: I run the RMS sportmax extra wide and have no tank bangin'.
I'd assume UFO's are similar.
________
video review
 
Last edited:
Depends on how wide they are, will get meaurments of the ones I tried to mount in a minute.

Mine were fairly narrow so hardly had room for the master cylinders, controls and grips. Also it was too low and I ended up snapping the return throttle cables support stem.
Need a set of risers that bring it up maybe half an inch from stock for mine to work.
 
They are same, same just a bit longer on the tips.
I had no clearance probs w/ a straight back level set up.

HERE WE GO
B23: 7/8" Flanders Drag Handlebar Wide Center:
Measurements Degree of Bend: 18 degrees
Pullback: 3.5"
Center: 9"
Width: 31"
Diameter: 7/8"

This is the spec on the bars RMS sells it is stamped FLANDERS B23 on the bar.
________
ipad guide
 
Last edited:
ok, my bars are 25 inches at the widest with 3 and 1/2 inches pull back on them. And like I said they only just didn't clear the faux tank.
 
mine fit fine, but Im getting bored of them, it seems like every cruiser around here has them
 

Latest posts

Back
Top