What did you do to your Vmax today? Part 2

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Learned a valuable lesson. Don't try to separate the slides to replace the diaphragm. The whole bottom breaks off when you do. Thanks youtube. :)

just buy JBM Industries (BS34) diaphragms and forget horsing around with taking slides apart or messing with wd40 to sneak diaphragms in without disassembly
. Check them out. They are of a different design that eliminates the two plastic washers completely. I can testify that these work well and are sure a snap to install. Also usually less expensive than anything else.
 
Weather over here is getting cold. :snow:
Got her ready for winter hibernation.. :tantrum::wave bye:
Now, I just have to put her in place and cover her up.
 
Put it on the lift for winter work. Changing all the rubber under the cover as they are getting hard. Lots of miles and heat cycles take their toll.


95 VMAX
 
Weather over here is getting cold. :snow:
Got her ready for winter hibernation.. :tantrum::wave bye:
Now, I just have to put her in place and cover her up.

Come on man! It's going to 55 Saturday and a couple days next week! :biglaugh:
 
I put my solid motor mounts in tonight. What a process that was lol. It’s a good thing I waited til this time of year to install them when it’s all tore down.


Sent from my iPhone using Tapatalk
 
Received some bar end mirrors and came up with a plan for installing them. Also a plan for installing saddlebags.
 
Come on man! It's going to 55 Saturday and a couple days next week! :biglaugh:

I know, I know.. It sucks putting her away for the winter, but since I have to calculate a 10-15 degree drop in temps while riding, with the gear I have, it's already getting a bit chilly for me..

I know, some guys ride with the show on the ground, but that's not for this kid. :surprise:

Well, shes topped off, mufflers covered, cylinders oiled, and battery removed. She's put on the side of the house and ready to hibernate. Moved her into position yesterday and it's supposed to get up to 60' today, :tantrum:
 
Last edited:
New toy for the 83 Venture. Hoping to get going on the fab work over winter break.
 

Attachments

  • 20171129_143255.jpg
    20171129_143255.jpg
    49.3 KB · Views: 45
Will do. Amassing parts still. Plan was to get the bulk done this winter but work decided to send me to training 4 months ahead of schedule so I'm busy with that. Mostly fab work to do and plan out all the plumbing. Wanted to keep everything as discreet and hidden as possible but it'll be tough.
 
Re: What did you do to your Vmax today? Part 2 in

Delivered my Vmax tot a specialist. My 1300 cc engine will be completly renovated. Wheels, frame, swingarm Will be powdercoated. Engine painted when done. New wiringloom and connectors. Etc etc
 

Attachments

  • IMG_5746.jpg
    IMG_5746.jpg
    86.4 KB · Views: 35
  • IMG_5749.jpg
    IMG_5749.jpg
    69.2 KB · Views: 37
  • IMG_5750.jpg
    IMG_5750.jpg
    71.2 KB · Views: 36
I went for a test ride after updating the shift segment and rebuilding clutch master cylinder and slave cylinder. All works all though shifting gears is not as smooth as i would like.
 
Back
Top