B-boost

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
I could not get the servo motor to track the Servo Desired setting with the way you have yours working.

I had to set it for Percent in the lower part of the graph to get it going.

Bazwells & my servo tab sheet attached below.

I definitively feel the Vboost kicking in though. This is the 1st I have had it automated on bike. I had toggle switch on it last year that I used in conjunction with a Push to Talk switch that is in the left grip.

This is much more fun !!

Gary

That's interesting Gary.
Did you get much out of the "Test" tab?
I got from that an idea that it only needed to move to about 2v to be fully open. Never even looked at percentages.

I reckon you must have a grin on your face. :biglaugh:



RempageR1 - can't wait to hear how it goes for you!
 
I installed my B-boost as per the directions from Bazwell and Gary, by the way excellent by both of you, the only issue I had was my soldering skills, looks good with the tape and heat shrink over it again thank you for all the time you put into this project excellent work guys! Massive improvements from the butt-dyno
44.gif
My bike has the boost wired 3/4 open for a year..

current map
By+3CLoQloz3AAAAAElFTkSuQmCC
5-24-2012 test 4.jpg

New map I will try tomorrow
Boost 6-1-2012 test 3.jpg

Thanks,
John:bike1:
 

Attachments

  • 5-24-2012 test 4.jpg
    5-24-2012 test 4.jpg
    52.8 KB · Views: 41
  • Boost 6-1-2012 test 3.jpg
    Boost 6-1-2012 test 3.jpg
    52.6 KB · Views: 36

Latest posts

Back
Top