gen 1 turn signal bulb #

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

dansvmaxx

Active Member
Joined
Jun 11, 2018
Messages
27
Reaction score
0
Location
Western mi.
I want to switch my turn signals to LED any idea what part # they are.. there not 1157 or 1156..
 
there not 1157 or 1156
Are you sure of this?? Maybe the previous owner changed them from stock setup??

1157 has two filaments and offset locking pins. 1156 has one filament and matching pin locks.

If your turning signals stay on, and glows brighter when turning, then I'd think you have an 1157 type bulb. If it only comes on when you select the direction, then 1156.

Either way, if you like the signal rate and the self canceling flashers, you'd have to put a load resistor in line with your LED replacement bulb, or opt for a separate flasher relay that does not rely on resistance for its flasher rate.

I used these on my tail. Since they did not flash or self cancel, it was an easy upgrade. Just had to make sure the polarity was correct..
IMG_20180909_164041951~2.jpg

The tuning signals were a bit of a PITA, because you need the correct polarity AND resistors. I opted to stay with the regular bulbs for turning.

I think I got these on Ebay. Price was decent.. something like 10 for 18 bucks or so.
 
The stock signal bulbs don't have the same pin offset as the standard car bulbs.
 
Back
Top