experts

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. capymotiv

    Time to ask the experts.

    Her is the situation. Bought used 88. Popped, sputtered and sometimes stalled at low rpm's but pulled like a horse after 2k rpm. Did the "shotgun" method. Engine seemed to loose throttle response and was just blah afterwards. Not quite a miss but almost as though a dead cylinder. Pulled carbs...
  2. 9

    Carb experts advice

    Long story short: Bike has been stored wet for the last year (seafoam and StaBil with fresh gas). When started, the bike starts and will idle on the choke as long as I keep the RPM above about 1500. Below that, it stalls out. Regardless of the choke setting or RPM if I so much as touch the...
  3. Buster Hymen

    In need of home window experts

    Unfortunately I'm shopping for windows for my home and I've never heard so much "their stuff is shit because of this" sales pitch in my life! :bang head: Does anyone here install or manufacture windows. All my information on windows before I started this came from looking on the internet...
  4. cgswss

    Any XP experts out there?

    I blew up my Macbook and have a older desk top right now. It an older dell running Windows XP. I have xfinty high speed internet and the PC is hard wired directly to the router/modem. This should be blindly fast, but is dial up slow. I have to believe there is something in the set up that I...
  5. T

    Any REputable VMAX Carb experts in the Dallas/FT Worth area?

    Hi, I just purchased a 99 Stage7 Vmax a few weeks ago, it seems to be running quite rich, I'm going to take a stab at messing with the Carbs myself but as a backup does anyone know of any shop or individual that can do carb work...for a fee of course any tidbits would be appreciated
  6. S

    Question for carb experts

    My bike is rich at anything less than 3k or so at wot. That's with stage 7 needles. It doesn't do it with stock needles, but I can't adjust them properly. Wouldn't drilling the slides actually make it pull the needle slower in a wot situation? It seems like it would require more vacuum, which...
  7. johnblaid

    Vboost Experts Please Comment

    I've been posting in another thread and searching the internet and I just did a test on my bike that baffled me. My bike does not run the Vboost Self Test, but when I removed the air filter box and could look down into the carb area, I started the engine, warmed it up, and ran it at high rpm...
  8. E

    Much needed help from you carb experts

    I have been having some serious running issues with my 05 lately. I have COP's, stage 1 kit, and K&N filter with the tunnel removed from the top of the airbox. No other engine mods. My bike had been sitting dormant for a couple of months during the heat wave called Phoenix and when I started it...
  9. srk468

    Any electrical experts out there?

    Ok decided to start a new thread about my issues, I've been having problems since I fired the bike up this year, been through the carbs 3 times now, checked dry and wet float levels and everything on the carbs is perfect but here's where shit get's weird... Originally when I fired the bike I had...
  10. fmcandrew

    Help form the Clutch Experts

    Last week I installed a Barnett pressure plate and new fibers. Took for a test drive and all seemed fine except that engagement was closer off the bars then I recalled with the diaphragm spring. This morning warmed her up good, shifted into first no problem, but engagement was 1/2 inch off the...
  11. K

    Question for the Clutch experts

    Got a question for you Vmax clutch experts out there. For a winter project, planning to inspect / possibly upgrade the stock clutch on my 06 Vmax that has ~9500 miles on it. No issues of serious slippage? yet. From the many threads / posts from the past few years, it seem the preferred clutch...
  12. VMAX1260

    question for the nitrous experts.

    as i have the most things i have to install my nitrous kit. i started bolting things on. i have to drill the carbs manifolds to install the nos nozzle's change the fuel/nos jets on the nozzle . i will install 16 nitrous/18 fuel. this will give 36 safe horses. cause this were installed on a...
  13. one2dmax

    UFO - The photoshop experts!

    This is actually pretty funny! I already posted on the web page a request to have him email me the big pics. http://planetvmax.com/homer-rides-a-vmax What a douche - lol. Somebody needs to photoshop Chong's face (of "Cheech and Chong") on a picture of him since I think he's so stoned it...
Back
Top