clamp

Hey everybody, quick question. The fuel line that feeds the fuel rail on the carbs has a special wire clamp on it that's unlike any other clamp on the bike. Well, I must have lost part of the clamp when I took the hose off, and now I can't get it to tighten down properly. I'm thinking about...

Did the torque specs change in 92 or is it still 14 for the top and 17 for the bottom (or whatever)?

I have managed to get the old exhaust off the bike, and I went to put the new exhaust on. This is when I discovered that I am missing one of the four exhaust clamps. Not a problem, right? I can just use one of the clamps from the stock exhaust! Wrong... they seem to be tack welded to the...

Hi, Just bought and installed UFO exhausts. Looks and sounds awesome! two question though; - How much should i tighten the exhaust gasket clamps? I tightened them until the can't move but the mufflers can still around the midpipe. Should I tighten it more or would i be fine like this...

Hey all. I was trying to get my bike dialed in better today and changed out my mains. Put everything back together and noticed the boot for #4 was not tightening all the way down. Tried to pull the rack back off and couldn't get it to come off that carb. Figured it must be tight enough and...

I got my new Bridgestones mounted and was torquing everything down. I misread the chart I was looking at and accidentally overtorqued the axle clamp bolt to the value for the caliper bolt and sheared it off :bang head: Fortunately, I was able to retrieve the part of the shank that was stuck in...

Could someone please tell me where the top of the fork should be in relation to the top clamp. When I bought the bike new in '03 the forks were sitting down 1/4 " below the top of the clamp and I thought this was correct since the dealer installed it that way. Been riding it like that ever since...

What should the triple clamp bolts be torqued to? Second, what type of bearings,( ball, roller ), are the steering bearings? Thanks. Jack.

OK so with my carbs on/off/on/off/on/off/on/off/on, in this fun tuning time of my life, the screws are starting to get buggered. mostly on the clamps holding the boots to the carbs/intake manifolds, but one of the screws holding on the airbox boots is too... now i ordered some new clamps, but...

Well, I've had problems with just about every part of my bike, and thanks to the forum here, I have rectified all of them, except the exhaust. I have serious exhaust gas coming from the left rear cylinder where the pipe joins the block. After careful observation (and exhaust gas inhalation)...

Do the handle bar clamp bolt caps remove easy? or will they be destroyed in the process of removal? I have a new billet one on the way I'm going to replace. Any Idea where they might be purchased if they do need to be replaced? Thanks. Ken.