rods

Sold New Carrillo Rods and Dished pistons for a 1340cc build Sold New set of stock lenght Carrillo H beam connecting rods 18 mm wrist pins and a set of gas ported dished pistons for a future 1340 cc blower motor. I also have these on an Ebay auction so the pricing might be a little different...

I'm in the process of gathering parts for my 89' max turbo project and came across the inexpensive performance connecting rods on eBay. I see that they come with ARP 2000 bolts which is a reputable piece but am concerned with the quality of the rods and small end bronze bushing. Just wondering...

I got a set of pistons on ebay that seller said were for a 1300 motor. They supposedly came out of a very low mileage motor, they were very clean so I got them. It was worth it to me to get them just for the rings. They are very nice, but they are 1200 VMax pistons. Probably be a loose fit in...

Got tired of the daughter wasting away another weekend in front of Disney Channel. So I plopped her on the back of the Max and hauled her to a local car show. Hehehe, it wasn't as bad as pulling teeth from a hen as I might be making it out to be. My 10-year-old loves riding the bike. The...

Hey guys just was wondering if you could give me a bit of info on where to find parts and if they are needed? I am putting together a new turbo setup and am going to rebuild the whole motor this time and do it right. I am figuring the power is going to be in the 180-200 horse range running a...

I know it's a bike forum but bikes , especially V Max's , just seem to go side by side with fast cars . Who's got a hot rod or muscle car out in the garage ? This is mine , where's yours...? http://www.dodgecoronetrt.com/featured/1969/1969-dodge-coronet-rt-7.shtml

I am instaling new carrillo rods right now and i am just vondering, whit clearence in the big end is best, yamaha says 0,021 to 0,043 mm ?

Well Guys, Looks like I have "hit the jackpot" so to speak. I did finally find a manufacturer (overseas) that will custom make a 4340 forged steel crank for us. We give them the specs and they will make it. The minimum order is 10 cranks which is way out of my budget to buy for shop stock...

I have 3 H-beam rods from a V-max. There are no markings at all anywhere on them except two have a small "U" on one end of the cap, and the 3rd has a small "J". I'm thinking they are Carrillo but not sure. Also where would be a good place to send them to make sure all is A-OK?