Search results

Is yer GoPro charged up?

Well glad to help, I just am getting off to late to get to my shop. I will pm those current sizes ASAP, Im thinking Friday evening.

Yea , I looked close, your machine already has the vent off the case, your set! Ill get you those PAJ1,2 and pilot sizes and youll be ready. Like I said they are stock or not far from it though. That 360 looks badass sick with the single side swing arm! Here's MammothMax's bike parked next to...

Hey, does'nt or did'nt that bike belong to the service writer at VForce on w.Colfax? Got to be it! He hooked me up with Greg Peck, the CO. Vmax tune master! R.I.P. The first thing he told me with my homemade Morley's set-up was to run 150 mains, the other three are close to if not stock, I will...

Hey Paul!

Not a big deal! Get your pin tool, de-pin the wires from the plug. Remove the stator cover. Pull the three wires out of the grommet an inch or two. Cut some heat shrink rubber oversize to cover the exposed wire, heat it to a good tight fit. Work each of the wires back into the grommet with a...

Get the parts from Sean. Its easy, easier than my set-up was to make. Gannon just did one, not sure if he posted pics or not. Mine shown with gauge and low fuel level light.

How bout a pic of the nubee bike

Hey Kyle, so was the black plastic cracked, but the white still keeping the coil intact? If so, think of all the coils that got/get tossed on that visual inspection alone. Yea ,I want to check out the video when your done.

Hey! Just saw this! OMG sorry man, that is a homefab, modmonkey creation strait out of me minds eye.

Hey, is Mammoth Max still around, they're based in Longmont?

I'd say you should carefully remove the 96 1200 and install 09 1700. You might get it to do a stoppie.

Oooops, I read on in the posts, I see your on the Rock, cool.

Hi, welcome in. Im in Denver, where in our great state are you?

Thank you sir! Yea , there are off the shelf sending units available now that make it alot easier to do than the frakinstien creation inside my tank LOL. A well known member (Gannon) just did one that looks great, works well with such sender. Pics Gannon, Pics!

Agreed, go now, go quickly to EXACTREP! Get the plastic 5 Gal.. While your at it pop a sending unit in, grab a matching gas gauge and your set!

Dont know how you "cleaned" the carbs, but after sitting as long as you say, I would send Ultra Sonic to the rescue. As yiu said "new to you" you'll find out these carbs have micro circuits that spay carb clean and wire wont touch. And yes that rust can cause alot of headache .

Yup! Dont buy a cheap tool when you can make it yourself.

Anybody else? Iv'e got a pretty clean one.

That oil is at Amazon, 2 second search showed Baker B1000 Glycerine, 23.80. My oil press gauge has gotten down to maybe a quarter full and doesn't shake, vibrate or anything else but give a good steady reading. Do we really have to keep it topped off? Sorry Wayne, I re-read your post ...