Search results

Okay, now you got me thinking if I need to replace, so has anyone with a PC-680 ever had one died on them before 10 years?

Battery Question I purchased a PC680 ODYSSEY Drycell Battery in 2010. This was supposed to be the cat's meow back in that year. Very heavy though (16 lbs) nearly twice what the OEM battery was. Lots of cranking amps and still works like new at the moment. However; I am probably pushing its...

Click Here!

repost

As they always say "Might of been drinking" except for the po po the media does not speculate.:confused2:

Two-tone, Red Ostrich and Black Leather with deep sculptured gel seat and pillion.

I read all seven pages and did numerous searches and still have not located where I can buy these vinyl inlays from

Was thinking about replacing my stock bulb with the below one; however, wanted to get some feed back on any electrical issues I may encounter when swamping this out. All advice and suggestions are appreciated. Xenon 5000K Super White Halogen HID Light Bulb H4...

Is this legal? Just had to share :biglaugh:

I believe it should be just the opposite for these reasons... The crush washer has a hard flat surface and a softer crushable surface. The flat hard surface goes toward the engine oil pan (as this surface is milled flat at the factory). Now since the oil drain bolt is forged so it may not...

Can someone recommend a good reasonable towing insurance agency. AAA wants $102 for the 1st year and $82 for the remaining years. Their Plus package will get you towed up to $100 miles and includes fuel or air no jump starts. Basically would like to have some type of coverage if I was to break...

Black plastic plugs for me as well, got them at an auto parts store in the upholstery trim section. Also put them in the holes where the brass plugs got drilled out to adjust the jet screws.

A little confused still, some folks say never use the back brake. Only use the front to stop in a straight line or to slow down hard enough to pre-load front folks in the straight line segment and letting off before making the curve for better front wheel tracking. What's your best advice...

Appreciate the advice, makes since. Will replace with the same product and adjust my braking habits more to the front. Thanks again for the safety advice.

That's a big help, explains the difference in the the FA88 vs FA88HH :-)

Perhaps the EBC FA88 are much softer than the HH. When I ordered the pads for the front and back at the same time they sent the HH for the front and FA88 for the rear. So that may explain why the fronts pads still have plenty of pad left. Oh well, I will be seeking out some back replacement pads...

I put the EBC FA88 on the rear, front was okay and still looking good. After a little over 4,150 miles I wanted to check to see how the front and back was wearing. The front still looks fine; however, to my surprise the rear I replaced earlier are near gone and needs replacement again. I do...