Search results

No cracks from what I can see wires seem to be arcing on one or more cylinders

does anyone still sell a complete kit for a 85 max? Interested if someone does

Yeah I had the half plate in, took it back apart and put a full disk in then took it back apart and put the half disk in when I figured it out

Thank you but DUH on my part it is stamped OUT HAHHAHAHAH

First one in is a fiber half plate in two parts then there is a cone shaped disk does it go in cone in? or cone out?

Even if I pushed it home.

Last summer I started getting my 85 back on the road. Went out today for the first time in about five years. Made it two miles and blew a fuse 😝. No spare. Walked home and back. Now to trace a intermittent short. And do something about the super draggy clutch

Pm me details

Factory? Or after market?

So during the fall I pulled my forks and fork brace off for seals and powder coating Coater did not realize the fork brace was magnesium and acid dipped it, destroying it they sourced another and powder coated it FIANALLY got around to installing them it appears the fork brace does not fit...

M4x.8 ? "Standard m4 thread is .7"

I left the drain screws in the fork tubes when sending them for powder coating. Anyone know the thread pitch so I can source/make new ones

Got the lower fork tubes back from Powder coater FINALLY Next time I am going thru a Shop directly, not a buddy thru his buddies shop took a month and they F'ed up the cross over support they didn't know it was magnesium and acid dipped it I guess it dissolved HAHAHAHA they got a replacement...

Probably not New springs are .95KG

Finally got the call my Lower legs and fork Brace are done at powder coater ALL new seals and wipers, Race tech springs, cartridge emulators question is Should I eliminate the air crossover tube? I think a oring is missing I have to take a closer look, tube after years is bent up pretty good Can...

150,000 second owner BFF was the first and he went 115,000 of them

I split the calipers Lightly clamped .055 thick Machinist scales over the transfer ports Air hose, with thick cardboard on top of bench they shot right out Id chucking three jaw chuck on a hand lathe with scotch bright pistons OD's look like new I usually use a microscope and a 125 wide and a...

SO my 1985 needs TWO seal kits one for each caliper Two seals and two dust seals in part number 1FK-W0047-00-00

Pulled my front calipers apart Pistons were stuck good I am confused seal kit it $80 Is that per side so I need two or per piston so I need 4?

May have to bite the bullet and pull the carbs to clean them I couldn't get mine right so I sent them for COMPLETE rebuild thing freaking purrs like a kitten again Brand new Exhaust But can't ride it yet cause front fprk seals blew and dumped oil all over the mostly seized front calipers...