Search results

Hi Mark, welcome, don't stress about parts, the Gen 2 is bullet proof, normal service items are freely available, the fuel range, you get used to & if you want to spend a little cash you can order a 22 liter aluminum fuel tank from the Netherlands. The Gen2 is a blast, what you do need to worry...

It's a great pleasure, let me know if you don't have the workshop manual, I can send it to you, very helpful.

Hi Del, welcome to the group. Post some pics of your 09, I also have an 09.

Hi Honor, the best thing to do is check the that the ABS test coupler's (under the LHS side cover) Green/Yellow wire is not shorting to ground (use a multi meter, measure resistance/continuity between the Grn/Yel wire & ground), then check for ABS fault codes, see what the fault code is & take...

Any update?

The issue arises due to the indicator circuit being linked with half of the brake light circuit on each side, when the indicator is activated it’s back feeding electronic noise to the ABS ECU which triggers the flashing ABS light. You need to install a 4 pin 12V relay on the yellow brake light...

I had no issues until I installed the integrated tail light, so I think it’s just a design flaw that the manufacturer could have easily rectified by using a few diodes in the circuitry.

Hi crynool, the reason I didn’t use a diode was because of the slight voltage drop over it and I had a sealed relay on hand. The backoff unit would also work perfectly, but not legal in my country (it would confuse the “challenged” drivers). I have put my relay setup on my bike and a friend’s...

The issue arises due to the indicator circuit being linked with half of the brake light circuit on each side, when the indicator is activated it’s back feeding electronic noise to the ABS ECU which triggers the flashing ABS light. You need to install a 4 pin 12V relay on the yellow brake light...

Okay so my fix works, I wired in a small 20A 12V relay on the yellow brake light wire (from brake light switches to pin 85 on relay) earth pin 86, take a battery live from the thick red wire on the voltage regulator (pin 30 on relay) connect the yellow wire to the brake light (pin 87 on relay)...

The fix works, will explain below.

Here’s the link, I have a fix for the blinking ABS light too, did the fix today, just need to test ride. https://a.co/d/h4XN7vj

Does anyone have a fix for this? I just installed the amazon integrated taillight and have this flickering ABS light. I found a 18 ohm resistor wired in on the old taillight on the yellow brake light wire and added it to the new taillight but the issue persists, I think the value of the resistor...

I had the same issue, your gear indicator switch under the transmission has a loose connection on the neutral pin due to vibration. Its on the left hand side, follow the harness going behind the cover. Drain the engine oil, remove the cover over it and remove the unit, the wires are caulked in...