I USED THAT 3M DOUBLE SIDED STICKY TAPE , THIS IS WHAT THEY USE TO SECURE FACTORY EMBLEMS ONTO CARS , THE CENTERS ARE OCTAGON SHAPED , SO I USED 6 STRIP'S LONG WAYS UP TOWARD THE POINT , THEN FOLDED THEM AT A 90 DEG. ANGLE & CAME OUT FROM UNDER THE SIDES WITH ALL 6 PIECES HANGING OUT , THEN CUT THEM CURVED FROM THE BACK SIDE WITH AN EXACTO KNIFE , SO THEY WERE EVEN WITH THE OUTTER DIAMETER OF THE SPIKE . THERES A LOT OF SURFACE AREA , AND THE 3M TAPE IS LIKE CRAZY GLUE ! ON THE FORKS I CUSTOM FIT THEM & TAPPED THEM ON WITH A RUBBER MALLET !
Enter your email address to join: