labargeblake
Member
Any suggestions on how to remove the front turn signals without removing the brake lines? And also, if I dont use a relay for the aftermarket signals, will it hurt my bike?
Replacing Turn Signals
- Thread starter labargeblake
- Start date
Help Support VMAX Forum:
Donny Daughtry
Well-Known Member
Take the 2 long allen head bolts out of the crown.
Donny Daughtry
Well-Known Member
Depends on what type aftermarket turn signals you are going to use?:confused2:
labargeblake
Member
I did take them out but the brake lines are in the way. I would rather not unhook them because of air getting into the lines if i do. But they are Krator Turn signals, but are not led
Donny Daughtry
Well-Known Member
You can try a 15mm open end wrench up behind the crown to break the nuts loose----The Krators should just plug in and work without relays.
davesax36
Well-Known Member
Factory signals are 17mm behind the crown.
Sent from my STV100-2 using Tapatalk
Sent from my STV100-2 using Tapatalk
![Bovemanx Motorcycle Phone Mount Holder, [150mph Wind Anti-Shake][7.2inch Big Phone Friendly] Bike Phone Holder, Motorcycle Handlebar Cell Phone Clamp, Compatible with iPhone 16 Pro Max Smartphones](https://m.media-amazon.com/images/I/51F+1sontPL._SL500_.jpg)
Unplug the wires from inside the headlight shell and slide a 17mm (as Dave pointed out) box end wrench up the wires to the nut.
Use an angled (15° I believe) box end, not a straight one
Use an angled (15° I believe) box end, not a straight one
Last edited:
