alignment

hi, im restarting my vmax project but going a totally different route this time. trying to create a cafe racer out of it. i have made a frame jig to hold my modified frame in place as i will be doing quite abit of changes to it. Question is, when i was trying to find the centerline from the...

I was cleaning the bike when I noticed the shift lever was missing the hold down bolt. I have a bolt to replace it. My question, is there an alignment mark on the shift lever that I align with on the shaft. I do see a dot on the shaft. Also does anyone have a picture of where the shaft should be...

I returned from a ride last night to discover that the rear tire had been rubbing against the drive shaft. The tire needs to be replaced now. And unless I can fix the alignment, the bike will have to be taken to a shop on a trailer. Could someone please explain (in newbie terms) how to fix the...

Not sure if any of you out there have done this conversion but wanted to reach out for some advice: I have got a diversion rear wheel and have had it fitted by a local garage, but it doesn't seem to be right. There is a large gap between the wheel and the shaft drive, big enough for me to...

This was recently brought up so I thought it would be good to post and maybe even make a sticky. Thanks to Thomas Powell for making this available years ago: http://imageevent.com/tppjr/bike/overhaul/engine Note that folder number 4 has the crank alignment info. Sean

Have you guys checked your front to rear offset/alignment.? What home method is most accurate?