banjo

Is the rear banjo 10x1.25 or 10x1?

Hi all, just putting some temporary bars on and need to adjust the banjo bolt for the front brakes to free up the hose.... does anyone know if it matters if the banjo bolt is facing down (almost 90 degrees vertical? The manual shows between 5 degrees horizontal, though will it really be a...

Ok, I bought a set of ZX-14 Clutch and Brake Masters with levers. Need to replace the micro switches and use the banjo bolt micro switches. Both measure the same and I think these are M10 x 1.25 (10mm x 1.25 pitch). Questions: 1. Is the size correct and pitch correct ? 2. Both identical...

To those of you that are running the two line SS front brake lines....what was your install order at the master cylinder? Did you put a copper washer between the fittings? Or did you just use two outer washers and none between the 2 fittings? -Mike

Is it 10mm x 1.25, or is it 10mm x 1.00. Or something different?