blocks

http://www.kfiam640.com/pages/timconwayjr.html?article=10744563:biglaugh:

While cleaning block up today for my winter project bike, I took some pictures of the 2nd drain plug on the 1200/1300 blocks. On the left side, directly under the middle drive cover there is a 14mm head bolt that goes into block and drains an oil pocket. This pocket appears to serve as a...

I have a question about installing lowering blocks in the front forks. Should I put a washer between the lowering block and the rebound spring? or does the spring just sit right on the lowering block? Thanks Richard

Anyone make their own lowering blocks for the forks? I want to use a progressive spring kit with their lowering springs but I was hoping to get a 1.5" internal drop. They only offer 1" or 2". Can I combine a homemade block with their lowering spring? Or just use a homemade block only. Worst case...

1" Schedule 80 PVC (Comment from 88VMX12 {Scooter} - I found that sch 80 PVC is just a bit too big in diameter to fit in my forks. I have an 1988 and used an electrical conduit PVC pipe) You have to subtract the length of the lowering blocks from your preload spacers. PCW lowering blocks are...