blowing

The 10amp ignition fuse keeps blowing,i checked all my fuses and the 10amp ign fuse was blown.I put a new one in and turned on the ignition,there was some ticking from under the guages then the fuse blew again.Electrics aint my good point,what can it be.

Howide, I am trying to inststal some Kury Silver Bullets. They have one power wire coming out of it. Grounded thru the metal housing. I am mounting them on the Forks. I keep on blowing fuses. Has anyone been down this road? Or any advice would be highly helpful. Jack

I have an 89 Max that keeps blowing the main fuse. Started the other day while riding, I'd put the spare in and it would run for a minute, then POP. Now I can't even get the fuse fully seated before it blows. I've already bypassed the keyed ignition switch hoping it was there, no luck. I'm down...

ok. have a '92. just put aftermarket turn signals on it. the aftermarket signals are only single filament so i capped the running light wire and hooked up the signals accordingly. worked great!... for two weeks. now, i keep blowing the 10a signal fuse which also leaves me without a brake light...

i have a 91 vmax that just started blowing the igntion fuse. 6 times. no changes were made to the bike. sometimes it blows as soon as i put it in gear other times after i drive a few miles. i changed fuses and with engine off turned on and of signals while in neutral held brake trying to blow...

Went to start up but I'm blowing the ignition fuse. Is it safe to assume the other circuits are OK (signals, headlight). These work with no problem.

Hey guys, i need your help. Last week I switched out the stock indicators for the halogen 'Vmaxicators' and tail/brake light for an LED swap. The problem I'm having is I keep blowing 10A fuses in about 10-15 minutes after i turn over the bike. I dont think it has anything to do with the rear...

Got my bike on thursday and for 1 thing the tacnometer doesnt go but now the main light and tach light wasnt going , later to find it had blown a fuse so fixed that then went on to look at the tacho prob cleaned the connections turned the key to find no lights again. What could be causing this ...

I having a problem with the fuse for the fan, it keeps blowing when the fan should be kicking in. I'm thinking there is a short somewhere?correct, if not what should I be looking at, to either test or replace. Thanks, Ron :cheers:

HI, I HAVE ASKED SEVERAL BIKERS, THIS, WHEN RIDING MY MAX, AND THE WIND HIT'S ME FROM THE SIDE'S, I AND THE BIKE MOVE SOMETIMES SO FAR, I'M IN THE LANE NEXT TO ME. DANGEROUS FOR SURE. I HAVE A 17" 190 REAR , MY RIM'S ARE ALMOST SOLID, THEY DO HAVE SLOT'S. BUT LONG 6" BY 1". I WAS TOLD THAT...