bottom

Rebuilt the forks and don’t remember the stock forks bottoming without air. What am I missing? Thanks

Hi all: I hope you're all staying warm. I have a question for you: My Max is using 1994 Yamaha YZF750 USD forks with a beautiful custom-made triple tree. The triple trees have a 50mm top diameter clamp and a 56mm bottom diameter clamp. Someone has recently given me a set of 1998...

This is my old max first time on a dyno. I have done all the work in my one car garage and this is just my baseline for tuning.

Went for a ride today, after bike almost not starting it was very sluggish right off the bottom, Had to crank the idle screw up as it was idling way too low. Seems good once its above 4-5k. This has happened out of the blue as it appeared to be running great the last time I rode. Whats the...

I have seen vmaxes with a scoop on the bottom of the bike behind the front tire. Were do you get one of these?

Found this cruising around ebay, complete case/crank/cylinders/pistons. I meant $95, I fail at the maths. Seems like a pretty good deal if someone needs a case. Sean?

So how does one remove one of these?!?!? Its stuck to the head-tube real tight :(

Hi all: I read Gleno's great post about steering, bearings, and race removal, and am in the midst of trying to remove the bearing race from the bottom of my '89 Max. Now, Gleno talks about using the diamond Dremel tips to cut thru that bottom race. I bought a bunch of them, and have ground...

getting ready to dissassemble my forks on my 86 to replace all seals and install progressive springs and I'm not sure of the size of the allen head cap screw at the bottom end of the forks(i think it's an allen head),I let a friend borrow my manual so I can't look it up right now.My bikes down @...

http://cgi.ebay.com/ebaymotors/GREEN-LIGHT-CHANGER-YAMAHA-VMAX-V-MAX-V-MAX_W0QQcmdZViewItemQQ_trkparmsZ39Q3a1Q7c66Q3a2Q7c65Q3a10Q7c240Q3a1318QQ_trksidZp3286Q2ec0Q2em14QQhashZitem180299047222QQitemZ180299047222

Found these shocks on the bay. Does the bottom one in the picture look like it's broken, or is it normal for the top cap to be able to be at that angle? :ummm::ummm:

Has anyone installed just the top Progressive (brand) springs and not the additional bottom one or two springs under the dampner? I know I'm being lazy but from what I think I've read not everyone seems to add them. If this is OK to do how long should the spacers be for a 2" drop?