bowls

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. D

    Cleaned Carbs and replace fuel inlet valves. Now no fuel is getting into the bowls

    As the title states I ordered 4 rebuild kits which consisted of O-rings and fuel inlet bodies/valves. I noticed the new inlet valves are stiffer then the original ones (figured the originals were worn) and they hold the floats in the low position when turned upside down. This is uncharted...
  2. EAGLEPI

    Question about draining bowls

    Each time I have removed my carbs which are more than I would have liked to. I drained the bowls by the drain screws, the other day I read a post where they unplugged the fuel pump and then ran the bike until it stopped. Is either way better? does draining with the drain screws drain it better...
  3. Buster Hymen

    How to remove carbs and access float bowls

    Here is a quick tutorial. I took these shots last time I had my carbs out. First off, you should get a service manual Step 1, strip off the scoops, faux gas tank and airbox These are the carbs! LOL ! :smileystooges: You need to loosen the lower clamps on the carb...
  4. Buster Hymen

    How to remove carbs and access float bowls

    Here is a quick tutorial. I took these shots last time I had my carbs out. First off, you should get a service manual Step 1, strip off the scoops, faux gas tank and airbox These are the carbs! LOL ! :smileystooges: You need to loosen the lower clamps on the carb...
Back
Top