brass

Anyone know where to get a brass pressed plug that goes into the carb housing where the needle valve sits? The previous owner knocked it out while trying to rebuild the carbs and I can't see them on the parts listing. Attached a pic to see the gaping hole left behind after his handywork. :bang...

Bikes been sitting for quite a while, and it didnt want to stay running unless the choke was on so i figured id pull the carbs and go thru them real good Its been a while since i rebuilt my last carbs and i may have forgotten somethings, anyhow... i ended up breaking the small brass bolt that...

Just throwing this out there. Im looking for brass. Got a reloader gonna be reloading and really getting into shooting. Looking for. .223, .40 sw, .357, 9mm, and 44 mag. I know times are tough but I figured id just throw this out there:th_biggun:

Anyone ever have a leak at the big brass plug at the fuel inlet to the carb?

The other day I had the air box off to try and get the carbs down in the boots better. One boot is always wet. After a bit I got it a little better but the carbs still don't want to sit down well. If I get 3 in well and try to get the 4th, the opposite corner pops out. After messing with it I...

Looking for clutch and brake levers made to look like the old brass knuckles! Have seen them on other bikes and would like to put them on my 88! Sure would look BADASS then. Maybe they could be made removable in case I needed them ... Anyone?

Sadly once again i couldnt make this but as i may be living in the South Island before years end next year will be a go . The Brass Monkey Rally has been going for 30yrs , its the biggest motorcycle rally in Australiasia . Its held in one of the remotest and coldest places in NZ and takes place...