brc

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. dannymax

    Diaphragm replacement at BRC

    Ship us your slides with worn out diaphragms, we will send them back with new, high quality, aftermarket, rubber replacements. (4) diaphragms mounted to your slides......$175.00 + shpg. (4) diaphragms mounted to your slides as part of a carb/cleaning project.........$155.00
  2. alorio1

    Dannymax (BRC) converts Cali carbs to Cajun carbs

    I sent Dannymax a rack of carbs I picked up from California that was gummed up so bad, the butterflies would not even move and the slides were stuck inside the carb bodies. They had been sitting for a couple of years with ethanol gas in them and were in bad shape mechanically and internally...
  3. dannymax

    #18-8 S/S Allen Bolt Kits @ BRC

    The two main reasons for stripped carburetor body bolts is 1) over tightening and/or 2) allen bolts too short. BRC has Allen Bolt Kits consisting of (89) bolts & (23) lock washers - broken down as follows: (16) #18-8 S/S 6mm Socket Cap side & bottom bracket bolts (16) #18-8 S/S 5mm...
  4. dannymax

    Helicoil Installation at BRC

    We install helicoils in stripped diaphragm & float chamber bolt holes....$15 each
  5. dannymax

    BRC Banners are up & running

    Click on either BRC Banner (the one in the banner rotation at the top of the page or the one with the other sponsor banners at the very bottom of the page) will take you to the BRC Shop flyer where there is info and pricing regarding carb cleaning & rebuilding.
  6. dannymax

    My experience with BRC

    Post comments about your experience with the BRC Carb Shop here.
  7. dannymax

    BRC Spider Saga supplement

    Some of you guys may remember the Chrome Spider thread from a few years ago....well this dude showed up today. No idea what kind he is but I saw him as the enemy and whacked his ass with a board! :rip: creepy spider!
  8. dannymax

    More wildlife activity at BRC

    I looked out the back window and about 50' up the hill, on the back lawn, is this. It looks like something was digging out around an old stump, there is a piece flung off to the side in pic #2, and chunks of sod are scattered about 15' away from the hole....whatever it was was a pretty powerful...
  9. dannymax

    BRC Carb Shop

    After a little organization.....:rofl_200: Really! Shouldda seen it before....Oiy!
  10. dannymax

    Poor Man's Can...or PMC from BRC

    Here's the final result on the 12" 'homegrown' can. It was easy enough to do, baffle was the one I made for the Holeshot can...just had to shorten it a couple inches, wrapped in 4 stroke glass packing and slid into a 4" X 12" aluminum tube, end cap from the old Holeshot can. The aluminum was...
Back
Top