dd

Hey guys, followed every step of the DD clutch mod but now can't pull in the clutch lever at all.What did I miss?

Just did the double D clutch upgrade. I left the half clutch in the back so I'd have some slipping not to break any parts. But it won't go into Nuetral when the bike is running. When the bike is off it goes into N without an issue. Had it apart to check 3 times now and I can't figure it out for...

Guys, Please don't hate me. I'm pretty good at searching things out and that's why I don't post so much - I usually just lurk. But, my clutch is going out and I've accumulated parts to replace it. But, I've seen a few references here on the DD mod which is something I'd like to include in...

So 3 years ago I had an entrapped ulnar nerv... It destroyed my left hand. The clutch on my bike isa little too tight. I will not be racing like Todd... I remember something being said about removing Springs. What all is evolved and which Springs. Thanks y'all

The clutch pull isn't bad. That doesn't bother me. But the motor doesn't respond like it used to. The bike feels slower. I am not sure if the clutches where slipping and the bike was moving faster because it was able to rev quicker or not. Not sure. But it will pop the frontend easier in first...

I would like to do the double clutch spring mod but before I do I just want to make sure I understand what needs to be done. As far as I can tell I will need to buy another clutch spring (1FK-16334-00-00), than all i have to do is remove the clutch over, remove the existing bolts, install...

Hey whats up? I'm doing a clutch job on my max, i've noticed some slipping since i did a 4-2-1 kerker & stage 7 kit last summer ,i guess the extra hp was enough to finish the clutch .I'm going to do a double DD while i'm in there. My question is,how many friction discs (26H-16307-01)do i need...