dimensions

I will be building a 2 x 4 box frame to use while lifting my Vmax by the frame tubes with an ATV lift. Some of you have already done this. Would someone post the dimensions? The center stand is retained with this exhaust and I don't have a cover over the spin on oil filter (1997 model...

I'm thinking quite seriously about going to a led headlight setup, but can't find the overall diameter of the lense. The setup I'm thinking of basically replaces the lense (and bulb obviously ) in the oe housing. Either that or going to a dual headlight system , but I can't seem to find one...

Does anyone know this dimension? Thanks in advance :biglaugh:

I have a friend who will turn me some aluminum motor mounts (bushings) out of aluminum -- I just need the dimensions. Does anyone have precise measurements of the stock mount dimensions or a tip on finding them? Thanks in advance. P.S. If I make some and they work out well, I might have him...

Here is a picture with the machining dimensions required to make an Ultima Inverted Harley type front end fit the Max. The stem supplied with the front end needs to be re machined as follows in the pic.

How critical are some of the dimensions on these solid motor mounts? I know a few of them are not, but I'm thinking mainly of the 1.100" diameter that fits in the bore in the engine. Does this need to be a friction fit or can it be a few thousandths loose? I'm not a real expert on a machinist...

Anyone know em? Im talking length width height If im not mistaken around 225 pounds right?