levels

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. johnblaid

    Oil Levels Hot and Cold...Is this Normal?

    1998 probably has been abused. I'm sure you may have read other threads about it recently. Just got carbs shotgunned and straightened out and engine was running well. Someone asked about hot and cold oil levels in the sight glass. when cold and on the side stand, oil is visible halfway up the...
  2. O

    wet float vs dry float levels

    I've noticed that setting my dry float with the 1.125" gap does not result in a 17mm wet float level. Any reason this would happen other than a bad caliper? I assume I should adjust based on wet float measurements rather than dry?
  3. trentsee

    Idle levels and adjustment

    Hey guys I got my Max serviced today at a local shop,The guy did an amazing job and the bike has never ran better,but now my bike when it's warm idles at 1300 I was wondering if I adjust the idle do I have to re-sync carbs....Any info would be appreciated
  4. maleko89

    How to measure wet float levels

    I've been asked how to do this and notice there isn't a sticky for this in the carbs section. First, here's a link showing where the float bowl drain screws are: http://www.vmaxforum.net/showthread.php?t=1570 The line on the carb body to measure from is on the left side of each carb just...
  5. coffee_brake

    I was checking the battery levels....

    Because it's been hot I thought it would be a good idea to check the levels in my standard-type battery. I know, I know, but the last battery left me stranded so I had to get what was available and that was this standard type battery. With my little clutch problem this week, the bike was VERY...
  6. vmax2extreme

    Front Fork fluid levels

    I have a 2005 vmax that I just lowered 1" with the progressive kit. I have heard that they newer forks take 20.9oz of fork oil, but everywhere I read state 15.3oz in the service manuals. What is the proper amount of fork oil and actually whats the proper measuring technique used to assure...
  7. EAGLEPI

    Question on battery fuild levels

    Hi Guys, I got my battery out and I am going to make sure the fuild levels are good before putting in back in and hooking up my Battery Tenfer Jr the off to storage Sat. All the fuild levels are between the lower and upper marls on the battery, more towards the top on most. I want to make...
  8. dannymax

    Wet levels float adjustment

    Yamaha wants around $40 for something similar to this for checking float adjustment wet levels. I used a piece of clear tubing, 1/4" id, .430" od (??) and 4 3/8" long. I don't understand the .430" od but it doesn't matter. I made a tick mark on either side of the tubing with a razor blade...
  9. maleko89

    Setting dry float levels on the bench

    Set for 1.125 inches to get a 17 mm wet level. Picture courtesy of Icepick. Mark #1098
Back
Top