linkage

I noticed the choke linkage rod that runs from carb #2 to carb #3 was hanging down the other day. Upon inspection I see that the e clip that retains the rod on the bracket on carb #3 is missing, it is still connected on the other end on cylinder #2 I don't see any breakdown of this linkage...

Would anyone have a set of junk/disassembled carbs that I could get the choke linkage from. The attached picture shows parts #64 through 73 that I would need. My Venture/VMax project would benefit from the manual linkage that the VMax's use instead of the handle bar/cable control that the...

Anybody know what the machine screw size is for the little set screw that ties the choke arm linkage to the carb. I have noticed that since I have had the bike, it drags 1 cylinder a bit on a cold start, running with the choke. I just figured out why, the left front cylinder has no set screw...

Hi folks: I've seen the term "accel. pump linkage" cited on the forum but don't know what it is or where it is on the Max. Anyone know? Thanks. Elimax

I've done some searching around, and I've seen talk of using R1 or Keihin flatslides or similar carbs. But these carbs generally don't come in the "square four" arrangement to fit the V4 VMX engine. How would one go about getting these carbs in such an arrangement to fit this engine? I figure...

My throttle cable is doing something strange. If i let go of the throttle the bike drops back to idle but if i twist the throttle more in the opposite direction (toward closed) it turns about 1/8 inch and will drop the idle down to a stall i have not looked at this closer yet i just parked it...

Guys I have gasoline and carb cleaner all over me, so I apologize in advance for not searching before asking this. Can the throttle linkage be removed without splitting the carbs? The screws to the brackes that locate them from front to rear are so f'ing tight that I can't get any leverage on...