measurement

Hello- I would like to know the diameter of the original hole near the needle, the one that is usually enlarged when installing a Dynojet kit Thanks, Henry

Could someone please tell me the height from the ground to the bottom of the center stand when it's up with stock pipes? Or the gap between the swingarm and the top of the right centerstand foot with stock shocks? I need to figure out how far down from my swingarm I can push it before I go ahead...

Doing some casting dimension comparisons and would like samples from as many bikes as possible. Below is a pic of what I'm looking for, either sae or metric is fine let me know which head or heads the measurement came from and the year of the bike. Thanks in advance! :worthy:

Please could someone just check the sizes for me on the pic below... It's the left hand pillion peg mount.. I need the centres between the 3 points shown to see if my pic is actual size. I've scaled it up best I can on the printer...I've got the parts coming from Captain Kyle but they'll be a...

Please could someone take a clear side on pic of the stock frame part under the right pillion peg hangar and an accurate (within 1/8") measurement of a clear point to point. I want to replicate this bracket as I am being creative with my frame and making it "resemble" a stock one albeit...

Ok. I've read the stickies more times than I care to admit. I think I'm doing this right, but I want to make sure. Could you tell me if I've just set this float correctly at 1.115? I'm going to proceed with the assembly of the other carbs, but I really don't want to have to take everything apart...

Does anyone have a front header pipe off the bike and a set of calipers that would get a measurement for me. I am looking for the I.D. at the head end of a front pipe. Thanks, Gary

Hi all, I need a measurement from the stock rear wheel, and would prefer not to have to take mine off to get it. If anyone has one laying around, and can get me the measurement, I would be appreciative. I need the measurement from the rim lip to the differential side upper most lip, as if...

I see that przemek posted this a while ago. Since then it looks like some more info has been added. I can't attest to the accuracy of the info but it seems like a good reference for anyone interested in going USD.