measuring

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. J

    Valve clearance measuring method

    Thanks to Sean and his shim kit and NaughtyG and his thorough "how-to", I'm doing my valve clearance adjustment this weekend. However, I've been thinking about the method used by NaughtyG to check the valve clearance vs the Service Manual method. Why did the Yamaha engineers come up with such...
  2. H

    Measuring Valve Clearances

    Fellow Vmax enthusiasts, a scenario/question I pose for you; When setting the cams for valve clearance measurement I followed the Yamaha Manual procedure as follows; Set T1 mark, make sure rear cams have timing marks pointing up and Cyl 1 is at TDC Rotate 180 Degrees and Cyl 3 is at TDC...
  3. C

    measuring stator voltage

    I am new. Great site, been doing alot of reading. My question is about measuring the AC voltage at the stator. I have read that you can measure this voltage by measuring across 2 white wires, and also that you can measure it by the red lead on a white wire, and the black lead on ground. If...
  4. WonkoTheSane

    Measuring engine speed

    I bought the Kindle version of the Cyclepedia manual for the V-Max (the images in the Haynes manual are not very clear). There are a couple of places, including carb sync (see attached), where it refers to using an inductive tachometer to measure the engine speed. The Haynes manual doesn't seem...
  5. Nielsen

    Measuring pickupcoils at Vmax 87' ?

    Hi Can someone explain this: In the VMax service manual its explained how to measure the function of the pickup-coils. Its told you have to measure 110 ohm +-15% between Orange-Black, Orange-Gray, Orange-White/Green and Orange-White/Red. If you look at the electrical diagram, I dont understand...
Back
Top