oiler

John blaid was not kidding when he described the difficulty in the install of the new pump gear. On a scale of 1-10, 10 being most difficult, I rate it nearly impossible and bring a magician. This of course is with the engine still in the bike. Dropped the washer for the new gear by the snap...

Hi I'm trying to install the Sean's HD oiler kit. When I removed the clutch basket i saw that the gear already is yellowed plastic does this mean that the HD oiler kit already is installed. Also the orange o-ring has a black o-ring over it, and it is still unpopped. Also how should i reuse...

I am posting these so that people can see what the PCW pro oiler is. I have seen a few questions asked on this so I figured I would share while my engine is apart. I would get the oil pump kit from Morleys Muscle, and I think the PCW pro oiler manifold is the way to go.

hi guys i d like to uprgrade my oil system, can someone tell me what s the difference between morley's hd oiling cure and pcw pro oiler mod? which the best if there's a "best" mod ? thanks for your help philippe

Holy crap. I am in the process of installing the Morley HD Oiling Kit. I just got my 45 degree snap ring pliers and removed the snap ring on the inside oil pump drive gear and pulled the shaft out the outside. The gear dropped out on my chest as I expected. I cleaned the shaft and the...

Are there any instructions for the HD oiler kit install or just the picture here: http://www.morleysmuscle.com/muscle-bikes/vmax/engine/hd-oiling-cure I'm trying to figure out the best way to loosen the 30mm nut that holds the clutch basket in place. I don't have a impact driver and would like...

What are the differences between the two? I did a search here but didn't come up with a whole lot of info...

Sean is on vacation or I'd call him, I'm sure I'm over my quota bothering him at night and on the weekends already. I've got an HD oiler from Sean in my hands getting ready to install and finish buttoning up this motor. It came with a thick OVAL shaped o-ring, the directions on Seans...

OK, I'm at a loss as to where this oval O-ring goes when installing the HD Oiler cure. Can someone give me a picture or a part number for the "elbow assembly" that it goes on?