procedure

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. dannymax

    Carb sync procedure for Carbtune

    I know this is posted in several locations on the forum and....here's one more. :biglaugh: I will refer to the carbs by their factory designation, following is the orientation front #2 #4 #1 #3 rear The first photo...
  2. H

    Confirm proper starter relay test procedure

    Can anyone confirm the proper way to test a starter relay? Yamaha manual states disconnect starter relay, probe blue/white wire coming from the relay - should test 12V. Can anyone with a working relay confirm this? Thanks.
  3. W

    Three years in storage - resurrection procedure?

    For various reasons, my 2006 vmax has been been in rough storage for just over three and a half years. It has not been turned over once during this time, and even worse it was put into storage with no stabilization (at the time I thought it would be there for only a couple weeks). My intent...
  4. O

    Pea shooter procedure?

    I have looked and looked for any step by steps to this procedure. All I seem to find is references to it. Can anyone point me in the right direction? Thanks.
  5. U

    Shotgun Procedure

    Just wanted to take this opportunity to express my thanks to the many members who took the time to answer questions, submit pics and step-by-step instructions on maintaining the Max. I had the no idle, no low speed power, throttle not retuning to idle, etc. I first did the "peashooter"...
  6. C

    Very Good Engine Cleaning/shining Procedure

    My neighbor has a Yamaha Warrior and it's engine is mostly black, just like my '01 V-Max. He shared an engine cleaning/shining procedure that works great for those of you who own the V-Max with the glossy black engine!! So here it is-- After washing and drying your bike, spray WD 40 onto a...
  7. Okie2ee

    Clutch Bleeding Procedure

    I looking for the clutch bleeding procedure using a standard auto vacuum pump. Thanks
  8. maleko89

    Procedure on lowering blocks

    1" Schedule 80 PVC (Comment from 88VMX12 {Scooter} - I found that sch 80 PVC is just a bit too big in diameter to fit in my forks. I have an 1988 and used an electrical conduit PVC pipe) You have to subtract the length of the lowering blocks from your preload spacers. PCW lowering blocks are...
Back
Top