progress

http://www.dragbike.com/tln-motorsports-hass-serafini-racing-prepare-for-historic-2016-season/ Interesting read.

https://youtu.be/9c4Rvz5stHE :ummm:

Well after a lot of headache with the paint, its done as good as I will do it for now.. Not happy with the faux tank cover so time for a leather bagster tank cover and tank bag. Fenders and small hard parts, scoops grab rail etc... turned out good.. While putting it all back together though...

Well I got it into the 11.70's and I know there is still more in it cause my best 60' time was 1.88 and even with my fat ass on it it should be able to get into the 1.7's still kinda low on mph only 114 but I know I'm still a touch rich so if I lean it out hopefully I with a good launch I can...

My 89 VMax. A Work In Progress or My Misadventures I put this here rather than in 4 separate threads in specific areas.. I started out the day by pulling the packing out of the Kerker Can, 4-1. This was a matter of removing 3 screws, pulling the end cap and core. Removing the packing from...

Hi there, Thought you may be interested in my progress with my 95 UK spec vmax... starting at the front, R1 USD forks billet 6 pot polished calipers wavy discs Taylormade billet wheeel and beefy yokes R1 mudguard Brembo brake and clutch levers/cyclinders Brembo R1 rear master cylinder Rizoma...

I gave this Carbine the nickname "Fugly 45" :biglaugh: I built it as a PDW for in home defense. The upper is by Ron Williams, it's a 10.5" barrel / 5.5" flash hider. on a DPMS High Ride Receiver, The lower is a Spike's Tactical, Standard DPMS Parts Kit with the exception of a JP Reduced...

yeah I just got back my Nissen master cylinders back from the chromer's! I installed them and the switch assemblies. I also decided to go ahead and hide the wires inside the handle bars. Also I went a bit crazy and wanted to do some extra machining on Sean's crank case breather that I...

Hey Folks, I just wanted to drop in and say hi. I am glad to be a new site sponsor and hope to be spending a little time here as my schedule allows. I also wanted to post a few things I have been working on. First being the Jumper Harness. Here is a pic of the prototype: I designed this...

Howdy, I've more closely inspected the bike and came up with a parts list, which you'll find in another post. Any help with parts is appreciated. I spent last Saturday going through the carbs. Used a lot of cleaner and compressed air. Jetting appears to be stock and the carbs weren't full of...