push

This is RE those stupid push clips that hold the grills in the radiator shrouds and rubber trim pieces on the scoops over the carbs. They are just like Jesus clips but the ring is solid making them even more fun to work with. I recently painted my bike which included the radiator shrouds and...

Haven't tried it yet, but wanted to ask if push starting the V is simple. 5mph start, then dump the clutch in first? Or does the rear tyre just lock up and skid?

I have been fighting this for a while. Every now and then my bike has been bogging down and dieing, usually after getting on the throttle hard. I finally noticed that when it happens the fuel pump is somehow loosing prime. When I turn the key on it pumps but will not pressure up. Took the...

94 Vmax, just did a fresh valve job and I home ported the heads with new Cometic gaskets and arp studs and installed fogger nozzles into the intakes... Runs like ****, keep fouling number 4 plug... Valve timing is perfect, I lashed all the valves, it has 185psi on all 4 cylinders.. I checked and...

Any thoughts here, I think my vmax is leaking engine oil out of the clutch push rod. I also noticed my 85 motor does not seem to have a place for a seal (around the clutch pushrod that goes into the engine) unlike like my 86 motor. Was this a design change. Thank you

Hi, I'am replacing the O ring on the push rod #2 with a aftermarket one. Anybody know if it's supposed to be a tight fit in the grove, or a little loose? Thanks.

Can someone tell me how to remove clutch push rod guide. I am replacing the seal and thought I would replace the guide also. Thanks in advance for any info on this matter.

I was wondering if any body had a mod to make the V-Boost come on with a switch without having to buy the tboost, sassy or any of the other systems. All I want is to have the V-boost work normally but when I hit the push button like push it once it stays on and push it again and bam it is off...

Having problems with my throttle cables. If I just connect the pull cable and open the throttle, carb spring action will return carb to closed position when I release grip. When I attach return cable it does not want to return smmothly to closed position. What is the reason that the return...