reassemble

Swapped forks recently. What is the torque spec for the front axle? Too tight and it puts stress on the wheel bearings and the wheel doesn't turn like it should. Too loose and I worry that it could work out because it doesn't have a lock bolt or clip.

Some of the folks here are aware of an issue I have been having with Toxic since my winter mod season started. When I began my mods I decided to remove the engine and wiring harness from Toxic to facilitate re-coating of the frame. As anyone who has attempted this will tell you, one has to be...

Well folks I am going to re-assemble my bike tommorrow after pulling the gas tank, rear wheel, rear fender and brake caliper. I went through the bike and decided I was going to replace the rear rotor, both sets of pads, grease the shaft drive, replace shaft fluid, replace brake fluid and of...