tighten

I installed some new tires and I'm trying to put the wheels back on. Following the instructions in the manual I purchased it tells me to torque down the rear axle before i clamp down the rear axle clamp Bolt. However, when I do that the rear axle spins. When it said to grease the rear axle I...

So I can add Valve Clearance Adjuments as another notch in my DIY Success Stories Belt. :eclipsee_gold_cup: And as maleko89 and one2dmax forcasted, I found my clearances either w/in tolerance or too tight So my question: Even though, Sean provided an explanation, my naivety is preventing me...

ok, the speedo and housing on my bike seem loose.(theres the speedo, rubber oring, then housing.) how the heck do you tighten the two pcs together? i havent removed it from the bike but i dont see any screws to tighten... they arent just clamped together are they?

My right fork is leaking oil out the damper rod bolt. I compressed the forks all the way and damper rod still spins and i cannot tighten the bolt. Is there a trick to this? forks are on the bike.

I have had the dealer check my valve clearance but I forget how many miles ago since it was in 87. I dont have over 25K on her though. Im thinking about doing it again because I dont trust anyone, but wondering if its worth it. How does the clearance get smaller?:ummm: