treatment

Hi everybody. I'm replacing the gasket (part # 3JP-12449-02-00) for the water pump on my '89 Max, and I'm wondering if I should pre-soak it in coolant, install it dry, or do something else to it before installing. Any suggestions? Thanks very much. Elimax

I will start this by saying I know SeaFoam is considered a very good product. However the 2 times I used to and using the correct amount for winter storage I had to have my carbs rebuilt the next spring. Now I know the Gen 2's a different but not sure how different they are when it comes to gas...

Ok, here's a product I haven't used, but reading on the webbikeworld.com site, I think I might! http://www.webbikeworld.com/t2/rust-treatment/ The fact it comes from a well-known supplier of mechanical goops is good-enough for me. I'm gonna try it and see how it works. I may also get some...

I was rec'd by Mark to put this stuff in my motor because last year when I did a compression check two of my cylinders were reading in the 185-190 range where as they other two were reading normal 160-165. My motor also used nearly a quart of oil every few hundred miles!:bang head: And it...

What's the best product to apply to the head gaskets when installing? I'm using OEM gaskets. Both the motor I tore down and the heads I purchased had some sort of black, silicone like, material on them. I figured you guys would know what works best to seal the heads to the block. Thanks Paul

After bitching last week about knowing more information on the new release than dealers I had spoken to, got the call this morning. Drove 45 minutes and was treated to IHOP for breakfast ;) 1 1/2 hours later after tons of questions about what "I" knew on the final product...$5K exchanged...