washers

I've installed the Barnett clutch on my 06 Vmax a few years ago and can't for the life of me recall if the washers provided with the six springs fit easily down the tubs of the purple clutch pressure plate. I'm installing the same kit onto my 2013 Royal Star Venture and the washers seem to not...

Nord-Lock washers secure bolted joints with tension instead of friction. Sizes down to M3: http://www.nord-lock.com/nord-lock/wedge-locking/washers/introduction/ https://www.youtube.com/watch?v=ZSOjxU3pdSU

anyone know of a local place that I might be able to get the idle mixture screws WASHER? just the washer, found one missing, maybe radioshack? Michael

Anyone else do this? I pulled the diaphrams (sp?) and removed the needles.. Then went and got plastic washers to place under the needles, to move them up and create a richer mixture an mid/high throttle openings. I have been tuning my carbs for the Vmax's new home, at our lake house (elevation...

Yesterday, I replaced the filter, engine oil and gear oil. Had a new OEM crush washer for the engine plug but not for the gear oil plug (paid about $2.75 at the Yamaha Dealer...ouch !!!). Afterwards, a bit of a leak at the gear drain plug. Tightened a bit more and it seems to have stop...

I cleaned my carbs today and as I was documenting all the jet sizes, needle shims, etc., I noticed that the manual and some of you here list the 2 PAJ sizes as 90/170. I'm running all stock and I have 100/170's in mine. I live in S. Oregon at an elevation of about 1500 feet. I have a Califonia...

I tried to re-use my copper hydraulic fitting washers when I recently replaced a o.e.m. rubber hydraulic clutch hose on my 1987 FZR1000 (the system is essentially the same as a VMax's) with a custom-made stainless steel/teflon hose. I bled it using the oft-mentioned method of reverse-feed...

can someone help me with where I can find the oil drain plug and radiator drain plug sealing washers for sale. i can't seem to find them online, maybe i am searching wrong any help would be appreciated thanks josh

So my manual says to always replace the washers when replacing fluids like coolant, engine oil and final drive oil so I look through all the schematics and pick out the right parts and put them in my virtual shopping cart and then notice that they are all the same part number! Wouldn't it be...

What is the washer count on the '95 stock jet needle? I am installing the stage 7 kit and am not sure what has been modified on this bike. Mine has the plastic washer w/pin, two washers, clip, wide washer, and then the spring. My service manual does not show the two washers between the plastic...

My idle mix screws and springs are in good shape. Anyone found a place to get the washer and o-ring separately?

anyone know of a good source for the bolts. Mine need replacing as I change the gasket. I'll be taking off the rear and from what I read I will not need to drain coolant or anything. someone on the yahoo tech group mentions removing the charcoal canister .... what the heck is that? I hate...