ABS light on

[xantonin]

Well, I just got this bike and didn't notice the ABS light wasn't supposed to stay on all the time. I downloaded the service manual and will be browsing it, but wanted to see if anyone had experience first.

Any suggestions on where to start on troubleshooting ABS issues? Thanks.

 

[MaxMidnight]

Any suggestions on where to start on troubleshooting ABS issues? Thanks.

I know I'm stating the bleedin' obvious but the Service Manual Section 8 p80 would seem to be a good place?
That will take you through in a logical sequence so you are more likely to get a correct diagnosis first time.

 

[xantonin]

I could have sworn I tested the bike, but long story short, the ABS did actually go away when driving. I must have just not been paying attention on the first ride.

 

[D Larson]

When I got mine, the ABS light was on for a couple of days. Then it cleared and has stayed off except for startup for four years.

Gremlins.

 

[John Henderson]

Yeah my ABS light turns off after little down the road and fluids have warmed up

 

[Madmaxx]

Does your Vmax have an LED integrated tail light installed?

 

[John Henderson]

Does your Vmax have an LED integrated tail light installed?

Mine does yes

 

[ShawnD]

When I had a 2011, the abs light turned off as soon as the electronics cycled through all it's functions. My 2020 has the light on until the bike is moving, around 3 or 4 mph. It's always done that, brand new. About a few hundred miles after changing the tires, it stayed on. This was about the time I did that brake test with the looped wire. That seems to have cured it.

 

[Madmaxx]

Mine does yes

It's a weird glitch that happens with the integrated tail lamp installed. Everyone that has the integrated tail light seems to have this issue (me included).

 

[child_of_fire]

Just wire in a resistor and the abs light will function normally.

 

[Ninjaparrot88]

I think its something to do with emi. (Electromagnetic interface) with the rear speed sensor. And new led taillights my opinion

It's a weird glitch that happens with the integrated tail lamp installed. Everyone that has the integrated tail light seems to have this issue (me included).

 

[GreggyG]

mine just did it also, I have an integrated tail light but sean morley's relay. it hasn't done it in 100 miles since the install but it did this morning. do I still need to wire in a resistor?