Parts Wanted Carburetor 1 Body

[TwelveGaugeSage]

Looking for the body from Carburetor 1. I would consider a whole set if the price is good.

 

[Fire-medic]

Beware no choke lever casting on the #2 (left front) carburetor. That would be from a Venture.

To name the carbs by number, draw the capital letter 'N' starting from the left rear as #1, left front is #2, right rear is #3 and right front is #4.

 

[dannymax]

PM sent

 

[gcurtis102]

I am looking for a carb body for carb #3. Willing to pay the going rate. Thanks to any that can help.

 

[Tommyshireoak]

I'm also after a number #3 carb body (rear right when sitting on the bike) if anyone has one please drop me an email.
[email protected]

Thank you

 

[gcurtis102]

I have looked for a #3 carb about 3 months now. Very tough to find a single. Many full sets available in quite a spectrum of conditions. From stripped down and corroded to rebuilt and running. I am wondering if there is enough interest in splitting up a set of 4. $75 a carb on the low end and $150 a carb on the top end.

Best approach would be for someone to buy a set and then sell to others.

Any interest in this? I'll buy the set and sell the others if it looks like they will all sell.

 

[dannymax]

I have looked for a #3 carb about 3 months now. Very tough to find a single. Many full sets available in quite a spectrum of conditions. From stripped down and corroded to rebuilt and running. I am wondering if there is enough interest in splitting up a set of 4. $75 a carb on the low end and $150 a carb on the top end.

Best approach would be for someone to buy a set and then sell to others.

Any interest in this? I'll buy the set and sell the others if it looks like they will all sell.

PM sent

 

[dannymax]

I'm also after a number #3 carb body (rear right when sitting on the bike) if anyone has one please drop me an email.
[email protected]

Thank you

PM sent

 

[Klang]

I’m looking for a #3 as well. I cleaned and rebuilt my carbs last week and discovered the #3 a/f screw was stripped and seized. I tried to extract it and broke my extractor off in it, pretty sure I was off center and caught some of the threads on the body. I'd appreciate any help finding one.