Choke part needed

[onspeed]

While putting carbs back together, I managed to snap the plunger/screw thing for the choke.

I need a new choke screw assembly, which is listed in the parts catalog (1GR-1410A-00-00 - Starter set), but it seems I can't buy a new housing? The screw portion sheered off so it would be much easier to simply replace the plunger + housing rather than try to chisel the remainder of the bolt out...

Any ideas? Anyone with spare carb parts?

 

[dannymax]

I can help you out, I have all those parts but not exactly what you want....the housing and brass plunger?

 

[onspeed]

Yes, housing and brass plunger (plus the screw part of it).

The plunger I can order from a parts vendor, but there's no part# by the housing in the yamaha parts diagram so I'm assuming it's not a piece I can buy separately.

Also, I managed to break the plastic nipple for the float drain. Can't seem to remove the remainder of the plastic piece though, is it glued in or a screw fitting? And is it a special piece or can i just go to home depot for a replacemnt?

 

[dannymax]

PM sent