Engine removal proceedure?

[Ojref]

Gents,

I want to get the frame powdercoated, and clean up the engine a bit. I might even get the cc's bumped while it's out. But getting it out wil be a decent task to perform.

I have a engine lift with a crank rocker/tilt on it if it will be of any use.. Is there a written procedure for performing this task?

Kind regards,

James Collins

 

[davidon]

Would recommend pulling frame off of engine.Take off front/rear ends, rad, gas tank..much easier to manuver

 

[one2dmax]

holy crap. That's way too much work. I can give you some advice when you are ready. Get yourself a couple of ziplock baggies, magic markers, and cardboard to make templates with.

Of couse I could always prep a frame with rake and sell it to you on an exchange basis.

Sean Morley